•  
  •  
Home   »   Accessories   »   Additives/Medications   »   Seachem   »   Reef Buffer

image-577393-SeaChem_logo.png

image-659555-RedSea-khCorallineGro-500ml-1.w640.png

Reef Buffer by Seachem Laboratories

Prices start at : $ 6.49 ea.

  • Raises pH to 8.3
  • Raises pH and carbonate alkalinity together
  • pK (8.6) allows for greater pH stability in a reef system where the bioload is significantly more than in a fish only system

SIzes Available :
  • 250g     
  • 500g
  • 1 KG
  • 4 KG  
  •                
Order Here
Choose Size
***Free Shipping with in the 48 Continental US on orders over $25.00*** or  Buy any " 2 Seachem products". Alaska, Hawaii and international Extra Fee.



Description

Reef Buffer™ will also raise carbonate alkalinity; however, it is intended primarily for use as a buffer in a reef system where the maintenance of a pH of 8.3 is often difficult. When pH is not an issue, Reef Builder™ or Reef Carbonate™ should be your first choice for a carbonate alkalinity supplement.

Reef Buffer™ is specifically designed to meet the needs and requirements of the closed reef environment. The principal difference between Reef Buffer™ and Marine Buffer™ is that the pK of Reef Buffer™ is slightly higher than that of Marine Buffer™. The pK of a buffering agent is equivalent to the pH around which that buffer most strongly buffers. One would presume, then, that the pK of a saltwater buffer should be 8.3; however, the multitude of organic acids produced by the inhabitants of a reef system forces pH downward to a much greater degree than in a non-reef, marine system. A buffer with a pK of 8.3 would end up yielding a pH more in the range of 8.0-8.2. Reef Buffer's ™ higher pK (8.6) allows for greater pH stability in a reef system where the bioload is significantly more than in a fish only system. Competing products are not designed specifically for the reef environment; the pK is too low (in most cases, pK 8.3). At this pK, the proper pH can never be reached in saltwater.

Competing products are not designed specifically for the reef environment; the pK is too low (in most cases, pK 8.3). At this pK, the proper pH can never be reached in saltwater. Reef Buffer's™ higher pK (8.6) allows for greater pH stability in a reef system where the bioload is significantly more than in a fish only system.


Directions

Check pH and alkalinity before use. Use 5 g (1 level teaspoon) for every 150 L (40 US gallons) to raise pH by about 0.1 pH units (this will also raise alkalinity by about 0.5 meq/L). For precise dosing, use the Seachem Digital Spoon Scale. Dissolve in at least 250 mL (one cup) of freshwater, then add to the tank. The pH of natural sea water is 8.25–8.30. In a well established reef system pH adjustment may be necessary biweekly to semiweekly. Dosing requirements will vary, but do not exceed the recommended dose without checking your pH and alkalinity (alkalinity should not exceed 6 meq/L).

If an alkalinity of 6 meq/L has been reached and a pH of at least 8.20 has not been attained or substantial cloudiness that does not clear within 15 minutes is encountered, then the system is not ionically balanced. To restore ionic balance perform a water change or adjust the magnesium and calcium levels to approximately 3:1 Mg:Ca.

DO NOT OVERDOSE: Excess alkalinity may enhance the loss of calcium, magnesium, and strontium. Do not directly mix with any calcium, magnesium, or strontium supplement. Best if calcium & carbonate additives are added on alternate days or at least 30 minutes apart.


Package size/volume:

250  grams
500 grams
1 kilograms
4 kilograms